Technical help

Looks to be the rear/side end. If you use the tape and have to fold over onto the downside, do both sides of the van and stick a decal over both.

Thanks Jk, just the job.

peedee

Your picture looks like it’s a rear quarter cap which Swift supplied under warranty because the original moulding split in the same place. The cap is stuck in place over the old crack, and ours, like yours has also cracked. We scraped down into the crack to remove dirt and provide a key. Then, after masking off, pushed epoxy (Araldite) into the grove. Fingers crossed. If it doesn’t work, masking again and a thin strip of glass fibre finishing tissue is planned. Failing which, a hole and polyurethane foam injection may work.

Is it a Swift caravan? If so, this is a fairly well known problem and I believe Swift have produced some plastic covers which can be stuck over the crack, after drilling stop holes, of course. I would expect that you could source these covers at any Swift dealer.