Rubber Seal
4 replies
KeithandMargaret replied on 27/03/2019 08:38
Oakley2017 replied on 27/03/2019 10:43
Takethedogalong replied on 27/03/2019 10:56
Ted on tour replied on 27/03/2019 18:33
Posted on 27/03/2019 18:33
I did it with the roof vent in-situ ok with a flat-headed screwdriver and a lot of patience. The trick was to start the seal in the middle of a straight run, and roughly stick it in position at some key points all the way round - this prevents the weight of the trailing seal pulling out all the work you’ve done. Then run it into position properly. It’s a little longer than you need, so trim it off when finished. Didn’t use any glue, and it has stayed in position for more than a year so far.
Murder on the arms though!
1 person likes this
Oakley2017
Motorhomer