New Zealand Motor Caravan Association
6 replies
MaggieR replied on 19/10/2016 21:48
mikebs replied on 26/10/2016 15:00
MichaelT replied on 26/10/2016 15:46
ScreenName0DF08650AE replied on 29/10/2016 23:45
Posted on 29/10/2016 23:45
Hi Mike,sorry to comment on a topic not relevant to this discussion but I did see on a earlier post that you had a problem with your autocruise step and no engine voltage showing on control panel , after changing the engine battery , I have the same fault on my Autocruise van, did you find the cause , many thanks for any info . Mike
mikebs replied on 01/11/2016 18:59
Posted on 01/11/2016 18:59
Hello Mike.
Re my step problem. Turned out the problem was blown fuse. There is a bank of fuses which sit atop the battery. One of these blew when the battery was swapped out. If I remember correctly it was 30 amp. This is non standard fuse which I sourced from Amazon. I hopre this is of some help to you.
mikebs
ScreenName0DF08650AE replied on 02/11/2016 02:55
Posted on 02/11/2016 02:55
Thanks for the reply Mike, that gives me a good starting point , I found it interesting to find out that a similar van could show up the same faults as my van after a battery change , so there is a link somewhere , so out with the toolbox tomorrow and check those fuses you mentioned
Cheers Mike
mikebs
Motorhomer