Shower door roller repair

could you not stick together again using something like araldite rapid steel. very good stuff.

Yep agree with lornalou, get the araldite out,make sure all parts are clean and grease free and glue all pieces together, roller bracket to door and pin to door and roller bracket.  

Dosen't look to disimilar to domestic shower enclosure.

Suggest take pattern to your local bathroom specialist. They may be able to offer similar set up 

Found a company online who say they will try to match the required part if you send them a picture. Have a look at Showerpart.co.uk

Hi, did you get a fix in the end?  I just noticed Prima Leisure have replacement rollers for round sliding showers, I was looking for a Bailey Senator part at the time.  Might be the same for yours?  £37 but look plastic rather than steel/plastic composite as per your photo.

https://www.primaleisure.com/product/2050001/shower-door-handle-and-hanger-kit

Hope it helps

Hi, please may I whether you ever found your replacement shower door roller, I'm asking as I have just had the same problem and unable to find a replacement. I would really appreciate any help you could offer.

Thank you

https://www.showerpart.co.uk/

Scroll thro their extensive range of parts.

I had the same problem, so I took my broken bits with me and visited Wicks Builders Merchants. I was able to get bits that did the job perfectly. As far as I can remember cost me less than £5.

I have fitted a set like that in the link, but still find the brass part of the roller catching on the rail, so making it difficult to open. Even with it adjusted correctly, looks like brass part of the roller is catching the top of the rail edge.,, anyone else seen this?

Its most like the offest on the cam is not enough to clear the rail even when adjusted